Descargar Imprimir esta página

Fagor 3FE-9214 Manual De Usuario página 86

Lavadora carga frontal
Ocultar thumbs Ver también para 3FE-9214:

Publicidad

Idiomas disponibles

Idiomas disponibles

The mains cord of your washing
machine is equipped with an earthed
plug. This plug should always be
inserted to an earthed socket of 10
amps.
If you do not have a suitable socket and
fuse conforming with this, please ensure
the work is carried out by a qualified
electrician.
We do not take responsibility for
damage that occurs due to the use of
ungrounded equipment.
NOTE:
Operating your machine
with low voltage will cause the life cycle
of your machine to be reduced and its
performance to be restricted.
3.4 Water Inlet Hose Connection
1
3
1. Your machine may have either a
single water inlet connection (cold)
or double water inlet connection (hot
and cold) depending on the machine
specifications. The white capped hose
95 cm
˜
3/4"
~ 95 cm
~ 145 cm
should be connected to cold water inlet
and red capped hose to the hot water
inlet (if applicable).
To prevent water leaks at the joints,
either 1 or 2 nuts (depending on your
machine's specifications) are supplied
in the packaging with the hose. Fit these
nuts to the end(s) of the water inlet hose
that connect to the water supply.
2. Connect new water inlet hoses to a ¾ ˝,
threaded tap.
Connect the white capped end of the
water inlet hose to the white water inlet
valve on the rear side of the machine
and the red capped end of the hose to
the red water inlet valve (if applicable).
Hand tighten the connections. If in any
doubt, consult a qualified plumber.
Water flow with pressure of 0. 1-1 Mpa
will allow your machine to operate at
optimum efficiency (pressure of 0. 1
Mpa means that more than 8 litres of
water per minute will flow through a fully
opened tap).
2
3. Once you have made all of the
connections, carefully turn the water
supply on and check for leaks.
4. Ensure that the new water inlet hoses
are not trapped, kinked, twisted, folded
or crushed.
If your machine has a hot water inlet
connection, the temperature of the hot
water supply should not be higher than
4
70°C.
NOTE:
must only be connected to your water
supply using the supplied new fill hose. Old
hoses must not be reused.
~ 140 cm
~ 95 cm
˜
EN - 11
Your Washing Machine
150 cm

Publicidad

loading