Publicidad
Idiomas disponibles
Idiomas disponibles
DC WIRING INSTRUCTIONS
1. Pull the 2 recessed wires from the rear conduit entry of the motor cavity (see Diagram 5). These wires will be cut
via an offset with the RED wire being longer than the BLACK wire. Straighten any frayed ends and prepare
the wire to be attached to the power cable. DO NOT CUT OR SHORTEN THESE WIRES.
2. Take the provided power cable and locate the end with the offset black and red wires. These wires have been cut
at different lengths with BLACK being longer the RED.
3. Feed the cable end with offset wires through cable gland fitting with the threads nearest to the end of these
wires (3" or closer). For easier installation, ensure the cable gland nut is removed from the cable gland
fitting (see Diagram 5). Move the cable gland cap nut inward on the power cable, if necessary.
4. Join the like color wires together and
crimp with electrical crimping tool.
5. Push the joined wires into the motor
enclosure conduit hole. You will need to
use the cable gland fitting to complete
this step. Refer to the Cable Gland
Installation Video on Fill-Rite's YouTube
Channel for more information. The
intention of this installation method is to
avoid removing the external motor switch
plate cover for an internal connection.
6. Screw the cable gland fitting to the conduit hole flush to the hex.
7. Screw the cable gland cap onto the fitting to secure the cable itself.
MOBILE TANK WIRING TO A VEHICLE ELECTRICAL SYSTEM,
NEGATIVE GROUND (COMMON)
1. Before electrical installation, place the switch lever into the OFF AND LOCKED position to prevent accidental
spillage once power is engaged to the motor.
2. Pass the electrical wires to the source of the vehicle power system, supporting as necessary and protecting
them from sharp edges, heat, or anything that could cause damage.
3. A negatively grounded system is common within most vehicles utilizing a 12V DC power source. In this
instance, the positive (+) battery terminal supplies power to all devices such as the ignition system. While
the negative (-) terminal is connected to the vehicle chassis.
4. The red wire from the pump will connect to the positive (+) battery post and the black wire will connect to
the negative (-) battery post.
5. If this circumstance is not present in the vehicle, please contact Fill-Rite Technical Support at 1 (800) 720-
5192 (M-F, 8am - 5pm ET). Otherwise, please continue with these instructions.
6. Fill-Rite requires installing a 20 amp fuse holder and fuse (not provided) for protection of the purchased
pump. Attach one end of the fuse holder to the end of the red wire, with the opposite end to the (+) positive
battery terminal.
7. The fuse is to be located as close as possible to the power
source of fuel storage and transfer. If the wiring to the pump is
greater than 15', refer to the applicable Electrical Code (national,
international, or local) to ensure the wire is of the correct size for
the application (see figure below).
Splice Connecter
Diagram 5
3/4" NPT Conduit Hole
Cable Gland Fitting
Cable Gland Nut
Splice Connecter
COMMON
FUSE
20 amp fuse
for 12V DC
Publicidad
