EN
English
INSTRUCTIONS FOR USE
- Before proceeding with its use, make sure that the trimmer is in
perfect conditions and that the battery is fully charged.
- Press the ON/OFF button to turn on the appliance, use it on the
desired body part.
- This trimmer is equipped with 3 guide combs of different cuts: 1
mm, 3 mm, 5 mm for different cutting length.
- Once the guide comb you want to use has been selected and
placed, press the ON/OFF button and the device will start to work,
then slide the device over the hair or part of the body you want.
- Once you have finished using it, press the ON/OFF button again
to turn it off.
- If you want to remove the shaving head for cleaning, turn the
head anticlockwise and remove it upwards.
- The head of your trimmer has rust resistant stainless steel
cutting blades that allow them to be rinsed under water if desired.
- Never clean the head with water while it is attached to the
trimmer.
- When "L" flashes, it means the battery power is insufficient, the
product needs to be charged.
- When charging starts, "H-M-L" will flash at the same time.
- Low charge L is on, M-H will flash at the same time.
- Medium load L and M are always on, H will flash.
- Full charge H is on.
CLEANING AND STORAGE
- Do not use abrasive detergents or products that could damage
the appliance.
- Never immerse the appliance in water or other liquids
- Clean the appliance each time you use the same to avoid
accumulating grease and other residues.
TECHNICAL DATA
Voltage 5V – Power : 5W
3,7 V ICR 14500 600 li-ion lithium battery
6