the head or foot of the bed.
CARE AND MAINTENANCE
The crib and mattress have a resistant fabric lining that can
be removed completely and washed. To remove the fabric,
follow the instructions in the paragraph "REMOVING THE
FABRIC. "
WARNING: Covering or removing the fabric may take a
few minutes and must be carried out by an adult. Regularly
inspect the product for signs of wear and damage. In the
case of damage do not use and keep out of reach of chil-
dren. When washing the fabrics pay close attention to the
instructions on the label. Do not use solvents, abrasive or
overly aggressive products.
Machine washable at 30°C
30° C
Do not bleach
Do not tumble dry
Do not iron
Do not dry clean 30° C
Check that the fabric and the stitching are in good condi-
tion after each wash.
WARNING: When covering or removing the cover, take
care when handling the fabric parts to avoid accidental
tears or damage.
WARNING: The fabric part of the crib that can be lowered
cannot be removed.
MAKING THE BED
The crib can be unfastened from the parents' bed when
making the bed. Just unfasten the grey buckles under the
fabric lining. When fastening the crib again to the parents'
bed, pull the straps again to make sure that the crib is cor-
rectly and securely fastened to the parents' bed. Make sure
that all the steps illustrated above in "Co-sleeping configu-
ration (fastened to the bed)" have been completed.
REMOVING THE COVER
20. Remove the mattresses
21. Detach the frame "D" from the legs "A", releasing the
bottom part by pressing the lever "A7" (Fig. 26) and the
top part by pressing the two buttons "D2.1" located on
either side (Fig. 27). Then pull upwards on the frame.
22. Unfasten the buttons "D1.4" and the straps with snap
buttons "D1.5".
23. Open the 3 zip fasteners "D1.1", "D1.2" and "D1.3" found
on the fabric.
24. You can now remove the fabric lining.
DISASSEMBLING THE CRIB
The crib can be disassembled completely to put it away in
the supplied bag. In order to complete the disassembly of
the crib after removing the fabric, remove the lower bar B,
repeating the steps illustrated in "ASSEMBLY OF THE CRIB"
in reverse order.
WARRANTY
The product is guaranteed against any lack of conform-
ity under normal use as specified in the instructions. The
warranty shall not therefore apply in the case of damage
caused by improper use, wear or accidental events. For the
duration of the warranty on conformity defects please refer
to the specific provisions of applicable national laws in the
country of purchase, where appropriate.
17