Publicidad
Idiomas disponibles
Idiomas disponibles
BEARD/MUSTACHE:
• Use small comb (D)(6mm) to straighten hairs for trimming.
• When trimming, first select Precision Trimmer Attachment. Starting under chin, follow the jaw
line back toward ear. Trim in multiple directions to capture all stray hairs.
• When thinning or tapering, use a small comb to hold beard in place. In opposite hand, hold
Groomer with cutting system facing outward while slowly moving Trimmer along length of
comb. The Adjustable Comb Attachment can also be used to achieve desired look.
MICRO SHAVER:
Use the Micro Shaver attachment to clean-up detailed areas. For best results, avoid holding at an
angle.
EARS:
• When trimmer inner ears, avoid inserting Grooming System (O) more than 1/4" into ear canal.
• Rotate Grooming System in a circular motion while gently moving in and out of ear canal.
EYEBROWS:
• Guide cutting edges to stray hairs along eyebrows.
• For best results, do not use the grooming system to define entire eyebrow.
NAPE OF NECK:
• Using a hand-held mirror is necessary if self-trimming.
• Lift hair off neck, using index finger to cover & protect hairs NOT needing trimming.
• Carefully touch cutting blade to neck, slowly moving the groomer in an upward direction until
stopped by index finger.
NOTE:
• Carefully insert groomer no more than 1/4" into nostril.
• Rotate Grooming System in a circular motion while gently moving in and out of nose.
CLEANING, CARE & MAINTENANCE
NOTE: Always clean Grooming System attachments regularly to ensure best performance and a
proper operating life.
CLEANING ATTACHMENTS WITH WATER
1. Remove attachment.
2. Rinse ONLY the attachment under warm running water. DO NOT use hot water ad this might
cause damage.
CLEANING ATTACHMENTS WITH BRUSH
• After first removing attachment, thoroughly brush and blow out hair clippings from cutting
system, attachment, and top of power handle.
CLEANING FOIL SHAVER
(DO NOT rinse oil over the foil shaver attachment as this is permanently lubricated.)
1. Remove attachment by pressing security latches on front of micro shaver.
2. Remove head, shake to remove excess clippings.
3. Replace attachment by gently snapping into place.
OILING BLADES & CAUTIONS (Oil not provided)
• Rinsing attachments under water (above) requires lubricating the cutting blades 1× monthly.
Using only light-grade oils (e.g. sewing machine oil), simply spread 1-2 drops lightly over cutters
with fingertip. Wipe away all excess.
• Use only light-grade oils as these will not evaporate nor slow down speed of cutting blades.
• Do not use hair oil, grease, or any oil mixed with neither kerosene nor solvent as these too will
evaporate.
CTP 1830
23
Publicidad
