N8WERK C011 Manual De Operación página 14

CLEANING AND STORAGE
Please Note!
■ Empty the dust container each time
after you use the device. The EPA filter
must also be regularly cleaned in order
to prevent overloading of the motor.
■ Do not use any sharp or abrasive
cleaning agents or cleaning pads to
clean the device. These may damage
the surfaces.
○ Make sure that the mains plug has
been pulled out and the device is
disconnected from the power.
○ Wipe down the motor unit (4) if neces-
sary with a damp soft cloth. Then dry
with a soft cloth.
○ Wipe out the recess for the dust con-
tainer (6) with a duster.
○ Check the connecting cable regularly
for any damage.
EMPTYING THE DUST CONTAINER
1. Pull the dust container (6) up and out
of the motor unit (4).
2. Reach into the opening and pull the
EPA filter out of the dust container.
3. Empty the dust container.
4. Wipe out the dust container with a dry
duster if necessary.
CLEANING THE EPA FILTER
1. Tap out the EPA filter and clean it with
a soft brush if necessary.
PLEASE NOTE: For thorough cleaning,
the filter can be rinsed under running,
cold (!) water. Allow the EPA filter to
dry completely before it is inserted
back into the dust container.
2. Insert the dust container with EPA filter
into the motor unit (4) (Picture C).
CLEANING THE UV­C LAMP
Please Note!
■ CAUTION – Danger of burns! The
UV-C lamp will become hot during use.
Allow the UV-C lamp to cool sufficiently
after using the device.
1. Undo the two screws on the cover (12)
of the UV-C lamp (13) and take off the
cover.
2. Wipe down the UV-C lamp with a dry
duster.
NOTICE: Make sure that you do not
touch the UV-C lamp with your fingers!
3. Place the cover back on and fix it in
place with the two screws.
STORAGE
Store the device in a dry, clean, frost-free
place that is protected from direct sunlight
and cannot be accessed by children or
animals.
TROUBLESHOOTING
If the problem cannot be solved with the
steps below, contact the customer service
department.
Do not attempt to repair an electri-
cal device yourself!
The device cannot be switched on.
The plug socket is defective.
► Try another plug socket.
There is no mains voltage.
► Check the fuse of the mains connec-
tion.
Low suction force.
The dust container (6) is too full.
► Empty the dust container.
The EPA filter is very dirty.
► Clean the EPA filter.
EN
13