VALBERG WF 1014 A AID W180C Instrucciones De Uso página 33

C
Cleaning and maintenance
• Filtering net of water inlet pipe is blocked or not (refer to maintenance and repair).
• Water pipe is frozen or not.
Press "Start/Pause" key after fault is removed.
If fault occurs again, please contact with after-sale service (refer to after-sale service.).
"F03" displayed on screen
The washer is not emptied. The washer stops the program being executed. Shut down the
machine and disconnect power supply. Check:
• Drain pipe is knotted or not.
• Filter in drain pump is blocked or not (refer to the cleaning of filter in drain pump)
IMPORTANT: Ensure that the water has cooled before draining the appliance.
• The drain hose is frozen up.
Plug in the appliance again.
Select and start the "Spin" programme or push the "On/off" button for at least 3 seconds and
restart the desired programme.
If the fault occurs again, please contact After-Sales Service (see "After-Sales Service").
If fault code "F13" is shown
Door lock is abnormal.
Start program for 3 times to check whether the door is closed.
Open or close it again.
After fault is removed, press "Start/Pause" key. If fault occurs again, disconnect power supply
and contact with after-sale service.
If fault code "F14" is shown
Door open fault.
Action: Press "Start/Pause" button. The washing machine will try to open the door.
The alarm will not be removed until the door is unlocked. Or, press the "On/Off" button to
restart the washing machine, and the alarm will be removed.
If fault code "F24" is shown
Water level reaches overflow level.
Remove it by pressing "Start/Pause" button and drain away water.
Select and start required program. If fault occurs again, disconnect power supply and contact
with after-sale service.
If else fault code "F04" to "F98" is shown
Electronic module fails.
Press the "On/off" button for 2 seconds to turn off the machine.
After fault is removed, press "On/off" button. If fault occurs again, disconnect power supply
and contact with after-sale service.
31 EN