HAEGER Light Boom SP-10W.003A Instrucciones De Uso página 4

Use
Charging the speaker
•
Before first use, please charge the BT
speaker to a maximum level.
•
To protect the performance of the battery,
avoid using the device while charging.
•
Note: The device has no power bank
function, it is forbidden to connect other
devices through the USB interface.
�� 1-3
•
Use a 5V
USB charging cable for the device to charge.
The charge time should be 4 hours.
•
Note: Charge continuously until fully
charged. If the battery operation time
becomes very short, the battery lifetime has
come to an end and we recommend to have
the battery replaced in an authorized
service.
Bluetooth connection
1. Long press Power button to power ON.
2. Then turn on the mobile Bluetooth and
search the Bluetooth name of the speaker
"Light Boom" and start the pairing process.
3. If you are requested to enter a pairing code
while your device and the BT speaker are
pairing, use the code: "0000".
Basic operation
To turn the speaker on, long press the power
button.
1. The device will start in Bluetooth mode.
2. If an USB stick is connected to the respective
port, the speaker will start playing the
contents automatically.
Volume and Track playback [+] [–]
Short press the Volume Up or Volume Down
button to increase or decrease the volume.
While playing music, long press [+] or [–] to play
the next or previous song.
[+] [–]
Short-press
disconnect Bluetooth connection.
A charger connected with
Button at the same time to
Switching Mode & TWS
Short-press to switch the function modes, Long-
press to pair or disconnect TWS.
Play/Pause and Light effects
[Play/Pause]
In the music being played: Press the Play/Pause
button to start or pause music playback during
Bluetooth connection or while a USB memory
media is inserted.
The BT speaker is equipped with ambient light
effects in the control panel area. To change the
light effect, long-press the Play/Pause button to
turn the three different light modes. To disable
the light effect long-press repeatedly until the
LEDs go out.
AUX IN
[AUX]
The speaker is equipped with a 3.5mm jack.
Your device can be connected to the BT speaker
via the supplied audio jack. First connect the
audio plug to your device and then to the
speaker's jack. The sound reproduced from the
speaker using AUX-IN mode will be transmitted
in mono.
Please note: before connecting your device and
speaker, make sure that the output signal from
your device is at the minimum level (minimum
output volume). This will prevent the speaker
from damage. When the audio cable is
connected, the speaker does not meet the
water ingression protection class.
Using USB memory stick
Insert a USB stick to the USB input port. (The
max. workable capacity is 128GB, if more it is
more than cannot work)
The contents will start playing automatically if
not long press the Mode button to switch mode.
Attention: Due to a number of devices on the
market, compatibility and playback support are
not guaranteed for all media. The memory
devices you want to connect should be tested in
advance and/or formatted as FAT32 file format.
The playback of protected media, files or
content stored inside them may fail.
[M]
[USB]