HAEGER Light Boom SP-10W.003A Instrucciones De Uso página 5

Hands-free call [
Under Bluetooth connection status, if there is
an incoming call,
Play/Pause button to accept the call or long-
press Play/Pause button to reject the call.
During the call, long-press Play/Pause button to
switch to talking on the phone or Short-press
Play/Pause button to end the call.
Reset Functionality
If the speaker does not turn off or respond, user
can short-press the RESET button in Aux Port
with a small round pin.
TWS Function (Bluetooth
connection for two speakers)
If you have purchased another identical
Bluetooth speaker, you can pair them together
for optimal stereo sound.
1. First make sure your device is not connected
to any BT speaker.
2. Turn on the two Bluetooth speaker device at
the same time. The default mode is
Bluetooth mode.
3. Select one BT speaker and long-press Mode
button to pair TWS, the speaker will make a
tone to start to pair, and there will be a
prompt tone again after paired successfully.
4. When the TWS is connected, turn on the
Bluetooth function of the mobile phone.
After searching for the name of the
Bluetooth speaker, click the name of the
Bluetooth speaker on the mobile phone to
pair it. After the pairing is successful, open
the player of the mobile phone to play
music, and the two Bluetooth speakers will
play the mobile phone synchronously
selected music.
5. If you long press the shutdown button of
any Bluetooth speaker, and the other
Bluetooth speaker will also be shut down
synchronously.
6. When the TWS is connected, the optimal
distance between the two Bluetooth
speakers is about 5 meters.
]
MIC
user can short-press
7. Press and hold the M button again to quit
the TWS function to hear music from one
speaker.
Troubleshooting
1. Automatically shut down when turned on
Auto-off voltage set by Software 3.3V. The
battery is low, please fully charge it before
use.
2. The player automatically shuts down or
restarts
The battery is low, please fully charge it
before use.
3. The charging light is not on, not charging
Pls make sure the charging cable is plugged
in properly and whether it is damaged or
normal, please use a 5V-1-3A charger to
charge the device.
4. Bluetooth status is silent
Pls make sure the Bluetooth is paired
correctly, and the Bluetooth device is
playing, and the volume is not at the
minimum.
Ingression Protection (IPX5)
The device is waterproof, allowing you to listen
to music near water. IPX5 ingression protection
– water passing through a 6.3mm jet is aimed at
all angles at a flow rate of 12.5 litres per minute,
at a pressure of 30 kN/m2 for 3 minutes and
from a 3m distance.
Warning: Always remember to seal the BT
speaker inputs with the original gasket and
make sure that the gasket is not damaged.
Never charge the unit during possible contact
with fluids. The unit is designed for contact with
clean water only without any additives. Avoid
exposing the unit
industrially treated fluids (such as lemonade,
sea/salt water, oils, etc.).
to contaminated or