Toyotomi zibro SRE 340 E Instrucciones De Uso página 78

In case of any
malfunctioning the
information display will
tell you what is the
matter.
I: When the mark
appears, the childproof
lock has been activated.
58
H
THE INFORMATION DISPLAY
The information display ¹ not only serves as an indicator of the (set) time and
temperature (Sections C, E, and F), it also indicates any malfunctioning of the
heater. The code on the information display tells you what is the matter:
CODE INFORMATION
e - 0
Temperature within the heater too high.
f - 0
Power interrupted.
e - 1
Faulty thermostat.
f - 1
Faulty burner thermistor.
e - 2
Starting problems.
e - 5
Tipping-over protection.
e - 6
Poor burning.
e - 7
Room temperature
above 32°C.
e - 8
Defective booster.
e - 9
Air filter dirty; or
Fuel pump dirty.
The heater has been in operation
continuously for a period of 69 hours
and has turned itself off automatically.
-- : --
Out of fuel.
+
-- : --
Too little ventilation.
+
e - 1 1
Too little ventilation.
+
Always contact your dealer for any malfunctioning not listed above and/or when
the error keeps occurring after taking the corrective measure as described above.
AUTOMATIC DEAC TIVATION
This heater is fitted with a safety system that ensures that it switches off
automatically after 69 hours of continuous operation. The following will then
appear in the display:
pressing the button
AUTOMATIC C LEANING MODE
When the heater has been burning continuously for two hours at its highest
setting, the burner will automatically start an autoclean procedure. The display
will show the autocleaning code cl:05 running back to cl:01. The procedure takes 5
minutes, during which the heater will burn at its lowest setting, while the burner
autocleans. When the burner is clean again, the heater will automatically switch
back to the highest setting again.
I
C HILDPROOF LOC K
The childproof lock can be used to prevent children accidentally changing the
heater settings. When the heater is burning and the childproof lock is on, the heater
can only be switched off. Other functions are blocked then. If the heater has already
been switched off, the childproof lock also prevents accidental ignition of the
heater. Activate the childproof lock by pressing the appropriate key
down for more than 3 seconds. The KEY-LOCK indicator (
information display (Fig. I), indicating that the childproof lock has been activated.
Switch off the childproof lock by pressing the key
than 3 seconds once again.
. If desired, you can switch the heater on again by
(see Section D).
WHAT TO DO
Cool-down and re-ignite.
Re-ignite the heater.
Contact your dealer.
Contact your dealer.
Contact your dealer.
Re-ignite the heater.
Contact your dealer.
If necessary,
re-ignite the heater.
Contact your dealer.
Clean filter
Contact your dealer.
Switch the heater back on.
Refill removable tank.
Ventilate better.
Ventilate better.
and holding it
) will appear on the
and holding it down for more