Operating The Appliance - Gaggenau AF2 Serie Instrucciones De Uso Y Montaje

Operating the appliance

Note: Switch on the extractor hood when you start
cooking and switch it off again several minutes after you
have finished cooking. This is the most effective way of
removing the kitchen fumes.
Operating the appliance
Control panel
Explanation
#
Fan on/off
1 Fan speed 1
2 Fan speed 2
3 Fan speed 3
Ž
Intensive setting
<
Automatic mode
œ
Saturation indicator
c
Light on/off/dimming
Setting the fan
Switching on
To extend the filter pull-out, press down lightly on the
middle of the handle strip. The fan will start at setting 2.
Press the + or - button to change the fan strength.
Switching off
#
Press the button. Slide the filter pull-out in.
Intensive setting
You can use the intensive setting if there is a large build-
up of odours and fumes/vapours.
ÿ
1 Press the button.
The fan starts at setting 2.
Ž
2 Press the button.
The intensive setting is activated.
Note: The intensive setting is a time-limited
maximum setting which can be activated at any fan
setting and in automatic mode. After approx. 6
minutes, the fan resets to the previously selected
fan setting.
3 To end the intensive setting early, press the
button or the button for another fan setting.
22
Fan run-on time
If you slide in the filter pull-out, the run-on time will be
activated for as long as the extractor hood is operating.
After approx. 10 minutes, the fan switches off
automatically.
Automatic mode
Switching on the appliance
▯
Press the
The fan starts at setting 2.
▯
Press the
The optimum fan setting 1, 2 or 3 is automatically
set via a sensor.
Switching off the appliance
<
Press the
The fan switches off automatically if the sensor no
longer detects a change in the air quality of the room.
The automatic mode lasts 4 hours at most.
Sensor control
In automatic mode, a sensor in the extractor hood
detects the intensity of the cooking and roasting fumes.
Depending on the setting of the sensor, the fan
automatically switches to another fan setting.
Default sensitivity setting: 2
Lowest sensitivity setting: 1
Highest sensitivity setting: 4
If the sensor control responds too quickly or too slowly,
it can be changed accordingly:
1 When the fan is switched off, press the
and hold it for approx. 4 seconds. The setting is
displayed.
2 Press the 1, 2, 3 or
of the sensor control.
Button 1 = Sensitivity 1
Button 2 = Sensitivity 2
Button 3 = Sensitivity 3
Ž
button = Sensitivity 4
3 To confirm the entry, press and hold the
for approx. 4 seconds.
ÿ
#
button.
<
button.
#
or button to switch off automatic mode.
Ž
button to change the setting
<
button
<
button