Publicidad
Idiomas disponibles
Idiomas disponibles
ENGINE
Maintenance,
repair, or replacement
of the
emission control devices and systems, which
are being done at the customers expense,
may be performed by any non-road engine
repair establishment
or individual. Warranty
repairs must be performed by an authorized
engine manufacturer's
service outlet.
ENGINE SPEED
Your engine
speed
has been factory
set.
Do not attempt
to increase
engine
speed
or it may result in personal
injury. If you
believe
that the engine
is running
too fast
or too slow, take your lawn mower
to a
Sears or other qualified
service
center
for
repair and adjustment.
CARBURETOR
Your carburetor
is not adjustable.
If your
engine does not operate properly due to sus-
pected carburetor problems, take your lawn
mower to a Sears or other qualified service
center for repair and/or adjustment.
IMPORTANT:
Never tamper with the
engine governor, which is factory set
for proper engine speed. Overspeeding
the engine above the factory high speed
setting can be dangerous.
If you think
the engine-governed
high speed needs
adjusting, contact a Sears or other
qualified service center, which has proper
equipment and experience to make any
necessary adjustments.
Immediately prepare your lawn mower for
storage at the end of the season or if the
unit will not be used for 30 days or more.
LAWN
MOWER
When lawn mower is to be stored for a pe-
riod of time, clean it thoroughly, remove all
dirt, grease, leaves, etc. Store in a clean,
dry area.
1. Clean entire lawn mower (See
"CLEANING"
in the Maintenance
sec-
tion of this manual).
2. Lubricate as shown in the Maintenance
section of this manual.
3. Be sure that all nuts, bolts, screws,
and pins are securely fastened. Inspect
moving parts for damage, breakage
and wear. Replace if necessary.
4. Touch up all rusted or chipped paint
surfaces; sand lightly before painting.
HANDLE
You can fold your lawn mower handle for
storage.
NOTE: The upper handle has an "anti-
fold" bracket located on the left side of the
handle. This bracket prevents the upper
handle from folding forward, which helps
protect control cable(s) from damage.
1. Squeeze the bottom ends of the lower
handle toward each other until the
lower handle clears the handle bracket,
then move handle forward.
2. Loosen upper handle mounting bolts
enough to allow upper handle to be
folded back.
IMPORTANT:
When folding the handle for
storage or transportation,
be sure to fold
the handle as shown or you may damage
the control cables.
• When
setting
up your handle
from the
storage
position,
the lower handle
will
automatically
lock into the mowing
posi-
tion.
SQUEEZE
TO FOLD
Operator presence
control bar
Mowing position
Lower
handle_._
FOLD
BACKWARD
bracket
14
Publicidad
