Descargar Imprimir esta página

Craftsman 917.388811 Manual Del Propietário página 7

Publicidad

Idiomas disponibles

Idiomas disponibles

The operation of any lawn
mower can result in for-
eign objects thrown into
the eyes, which can result
in severe eye damage.
Always wear safety glasses or eye shields
whileoperatingyourlawnmowerorperform-
ing any adjustmentsor repairs.We recom-
mendstandardsafetyglassesora widevision
safety mask worn over spectacles.
HOW TO USE YOUR LAWN
MOWER
ENGINE CONTROL
The engine is controlled by a throttle
control located on the side of the upper
handle. CHOKE position is for starting a
cold engine and FAST position is for start-
ing a warm engine and normal operation.
The engine speed is not adjustable.
"_ FAST
CHOKE
,"-""
ENGINE ZONE CONTROL
ACAUTION:
Federal regulations require
an engine control to be installed on this
lawn mower in order to minimize the
risk of blade contact injury. Do not under
any circumstances
attempt to defeat the
function of the operator control. The blade
turns when the engine is running.
• Your lawn mower is equipped with an
operator presence control bar which
requires the operator to be positioned
behind the lawn mower handle to start
and operate the lawn mower.
TO ADJUST
CUTTING
HEIGHT
Raise wheels for low cut and lower wheels
for high cut, adjust cutting height to suit
your requirements.
Medium position is
best for most lawns.
To change cutting height, squeeze ad-
juster lever toward wheel. Move wheel
up or down to suit your requirements. Be
sure all wheels are in the same setting.
NOTE: Adjuster is properly positioned when
plate tab inserts into hole in lever. Also, 9-
position adjusters (if so equipped) allow lever
to be positioned between the plate tabs.
LOWER WHEELS FOR HIGH CUT
_/_
_._j
Plate tab "-_k'_
RAISE WHEELS FOR LOW CUT
Lever
7
TO CONVERT
MOWER
Your lawn mower was shipped ready to be
used as a mulcher. To convert to bagging
or discharging:
REAR BAGGING
• Lift rear door of the lawn mower and
place the grass catcher frame hooks
onto the door pivot pins.
• To convert to mulching or discharging
operation,
remove grass catcher and
close rear door.
Rear
Grass
catcher
handle
Catcher frame hook
SIDE DISCHARGING
• Rear door must be closed.
• Open mulcher door and install dis-
charge deflector under door as shown.
• Mower is now ready for discharging
operation.
• To convert to mulching or bagging opera-
tion, discharge deflector must be removed
and mulcher door must be closed.
SIMPLE STEPS TO REMEMBER WHEN
CONVERTING
YOUR LAWN MOWER
FOR MULCHING -
1. Rear door closed.
2. Mulcher door closed.
FOR REAR BAGGING -
1. Grass catcher installed.
2. Mulcher door closed.
FOR SIDE DISCHARGING
-
1. Rear door closed.
2. Side discharge deflector installed.
Ar_CAUTION:
Do not run your lawn mower
without rear door closed or approved
grass catcher in place. Never attempt to
operate the lawn mower with the rear door
removed or propped open.

Publicidad

loading