Descargar Imprimir esta página

Atlantic 73858 Manual Del Producto página 2

Publicidad

Idiomas disponibles

Idiomas disponibles

Introduction
Thank you for choosing Atlantic's Stainless Steel and/or Copper Finish Spillways.
Constructed of stainless steel, Copper Finish Spillways have an additional antique copper
plating over the stainless steel for a warm traditional look.
Atlantic 304 Spillways are constructed of 304 stainless steel and are intended for fresh
water use only.
Atlantic's 316 Stainless Steel Spillways are designed specifically to be corrosion resistant
in chlorinated pool water, salt water and acidic environments. All 316 Stainless Steel
Spillways include a 1/ 4 " bonding lug for grounded pool applications.
ATTENTION
316 stainless steel withstands corrosion when immersed in swimming pool water because
the chlorine concentration is typically mild (1 – 5 ppm). However, the areas above the
waterline that get splashed frequently are extremely susceptible to corrosion. As the
water that splashes on the stainless steel evaporates, the chlorine left behind becomes
highly concentrated. These deposits are very corrosive and will discolor, rust, pit, and
corrode stainless steel regardless of grade if not maintained properly. 316 Spillways used
in swimming pool installations should be rinsed regularly with fresh water to remove
accumulated chlorine deposits.
Installation Requirements
• 304 Spillways are designed for use in fresh water Pond-free and Formal Spillway applications.
316 Spillways are specifically designed for use in chlorinated and salt water pool and spa
environments. Spillways are not intended for use in water gardens, ponds or any other
installation with plant or aquatic life.
• Atlantic Spillways can support 80lbs. per linear foot of evenly distributed weight over
the top of the Spillway. (Ex. A 24" Spillway can support 160 lbs.) If the weight of the wall
stone and caps above the Spillway exceeds the recommended weight limits a lintel must
be installed above the Spillway to carry the excess load.
• Atlantic Spillway are designed to easily install in dry stack garden walls utilizing a standard
4"H x 8"W x 12"L wall block. Although any size wall block can be used, a 4 x 8 x 12 is ideal as
it requires very little alteration when installing the Spillway.
• Copper Spillways have two small holes in the top rear corners that are required for plating.
The holes are sealed with silicone plugs. Plugs must be installed to seal the spillway during
use. Two additional silicone plugs are included.
Spillway
SS12 / CS12 / SS12-316
SS24 / CS24 / SS24-316
SS36 / CS36 / SS36-316
Installation
The opening in the wall where the Spillway will be placed is important to the function of the
Spillway. The bottom of the Spillway must sit on a flat surface and be fully supported for its
entire length. The Spillway must be level side to side and front to back to for proper
water flow.
2
Stainless steel can corrode if not maintained properly.
Maximum Falls Height Above Basin
24"
30"
36"
Flow Rate
1200 GPH
2400 GPH
3600 GPH

Publicidad

loading