Startup; Start Up Infinity A Only - BWT Infinity A+AP Instrucciones De Montaje Y De Servicio

10

Startup

Check that the filter and flushing water pipe have
3
been properly installed.
Slowly open the stop valves up- and downstream
of the filter. Deaerate the pipework at the next
bleed point downstream of the filter, and drain
water briefly.
Check the seals of the installation and filter for
leaks.
Insert the cable plug connector of the power supply
24 V
unit into the socket (24 V).
Plug in power supply (3) unit to main. The first
back-washing cycle is performed automatically
(during backwashing the illuminated segments on
the display turn).
The factory setting
10.1

Start up Infinity A only

The required backwash interval must be set on
the filter.
Press Set to set the interval
Set
Press Set for 5 sec.
Display
Display dots flash; device is in programming mode
Pressing the Set key again steps up the number of
h (hours) or d (days).
The hours h run from 1 - 24, followed by days d from
2 - 56, followed by the hours again etc.
Press the Set key until the desired value has been
set.
The value is saved 10 seconds after the last input.
The display dots disappear. The unit backwashes.
The filter is ready for use.
(7 days) appears.
(7 days) appears
EN
27
27