BEARWARE 305547 Manual Del Usuario página 15

7.2 Enabling/disabling the alarm
Slide the "ALARM 1" (1) switch to the "ON" position, the symbol is shown on the
display.
When you slide the "ALARM 1" (1) switch to the "OFF" position, the symbol is
switched off.
The setting procedure for Alarm 2 is the same as for Alarm 1. But, use the
"ALARM2" (6) switch for this purpose.
When the alarm goes off, the alarm symbol starts flashing. Press one of the fol-
lowing buttons to stop the alarm. "TIME SET" (2), "UP" (3), "DOWN" (4), "ALARM
SET" (5).
The alarm switches off automatically after 2 minutes.
7.3 Snoozing the alarm
While the alarm clock is ringing, press the "SNOOZE" button on the top of the
device to stop the alarm clock, the alarm symbol starts flashing. The alarm goes
off again after 5 minutes.
Press one of the following buttons to stop the alarm. "TIME SET" (2), "UP" (3),
"DOWN" (4), "ALARM SET" (5).
7.4 Turning off the alarm
To turn off an alarm, slide the respective switch to the "OFF" position.
8. 12/24 hour display
Press the TIME SET button briefly in normal-time mode to toggle between the
12/24 hour time system mode. "AM" or "PM" is displayed in the 12-hour mode.
15
English