Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
CHART
SYMPTOM
CAUSE
REMEDY
Blade stops
under a load
or does not
turn when
switch is
pressed.
• Forcing blade into material.
• Blade guard clogged with debriE
• Edge guide bent toward blade.
• Unit unplugged.
• Fuse blown/circuitbreaker off.
• Wom spring washer.
• None of the above.
• Cut at a slower pace.
'.,Clean blade guard area.
;• Replace edge guide.
• Plug unit into a 120 volt outlet
• Replace fuse/reset breaker.
• Replace spring washer.
• Contact your SEARS Service
Center/Dept.
Blade turns
•Wheel depth incorrect.
,Adjust wheel to proper depth.
but will not cul • Incorrect or worn blade.
• Replace blade.
• Worn spring washer.
• Replace spring washer.
Edger drags
,Wheel depth incorrect.
•Adjust wheel for proper depth.
ground or
,Wheel mount(s) broken.
•Contact your SEARS Service
cuts too
Center/Dept.
deep.
10
Publicidad
