Display Description; Led Descriptions; Table 1.3 - Led Functions - Reliance electric SP200 AC Manual De Instrucciones

English

1.2 Display Description

The keypad has a four-character display (labeled 9 in figure
1.2) which is used to show parameter numbers and
parameter values. The keypad monitors its connection to the
drive and will display
due to electrical noise or a hardware failure.
If the drive faults, the full display will flash to indicate the
presence of the fault, and the fault code will be displayed.
The , , and keys can still be pressed to change
parameter number and value, but the display will continue to
flash until the fault condition is reset. If the fault condition is
reset without the operator changing the parameter number or
value, the display will return to the parameter value that was
selected prior to the occurrence of the fault.

1.3 LED Descriptions

The keypad has four status LEDs (labeled 10 in figure 1.2)
which serve as run, program, and direction indicators. Table
1.3 describes the LED functions.
Table 1.3 – LED Functions
Name Status
PROGRAM Off The keypad is in display mode.
On The keypad is in program mode.
RUN Off The drive is not running or jogging.
On The drive is running or jogging.
Flashing The drive is changing directions.
FORWARD On If keypad control is selected (P-10 = 1), this
LED will turn on if the direction commanded by
the keypad is forward.
If keypad control is not selected, this LED will
turn on when the drive is running forward.
REVERSE On If keypad control is selected (P-10 = 1), this
LED will turn on if the direction commanded by
the keypad is reverse.
If keypad control is not selected, this LED will
turn on when the drive is running reverse.
1-4
if this connection fails
Description
SP200 AC Drive Remote Keypad