Resol FAP13 Instrucciones página 8

RESOL FAP13
Outdoor temperature sensor
2. Electrical connection
1
2
3 4
Important notice:
We took a lot of care with the texts and drawings of this
manual and to the best of our knowledge and consent. As
faults can never be excluded, please note: Your own calcu-
lations and plans, under consideration of the current stan-
dards and DIN-directions should only be basis for your
projects. We don´t offer a guarantee for the completeness
of the drawings and texts of this manual - they only repre-
sent some examples. They can only be used at your own
risk. No liability is assumed for incorrect, incomplete or
false information and / or the resulting damages.
Please note:
The design and the specifications are to be changed without notice.
The illustrations may differ from the original product.
8
|
the cables into the holes and pull them slightly back, such
that the edge of the gland is slightly turned to the outside.
Thus the device is protected against moisture.
Connect the cable which leads to the controller to the
must not be placed in a gland together with cables car-
rying 230 V. If the connecting box is used outdoors, it is
recommended to pierce the condensation water hole at
the bottom after the device has been installed.
Disconnected Pt1000
temperature sen sors can
be checked with an ohm-
meter. In the following ta-
ble, the resistance values
corresponding to different
temperatures are listed.
Reprinting / copying
This mounting- and operation manual including all parts is
copyrighted. Another use outside the copyright requires
the approval of RESOL - Elektronische Regelungen GmbH.
This especially applies for copies, translations, micro films
and the storage into electronic systems.
Editor: RESOL - Elektronische Regelungen GmbH
EN
Resistance values of
the Pt1000-sensors