Assembly Instructions
WARNING ALWAYS UNPLUG THE MACHINE BEFORE ASSEMBLY/INSTALLING ACCESSORIES .
Handle Tube
Tools Needed:
•
(2) 7/16" Wrenches
1 .
Before assembling the handle tube, ensure the handle
clamp is positioned with the hole of the tube facing the
motor . (Fig . 1)
2 .
Slide the handle tube through the handle clamp . (Fig . 1)
3 .
Hold the yoke vertical and insert the tube over the yoke .
(Fig . 1)
4 .
Turn the handle tube so the insert "Lavex" faces the
motor . Align the holes on the tube and the yoke, and
place the two screws in the holes with the heads toward
the wheels . (Fig . 1)
5 .
Place the safety nuts on the screws with the flat part
facing the screw . Tighten by hand, then hold the head
with one 7/16" wrench and tighten the nut with the other
7/16" wrench . (Fig . 1)
6 .
Tighten the adjusting knob clockwise at a desired handle
position until the handle clamp does not slip when tilting
the machine . (Fig . 2)
7 .
Connect the motor cables, making sure the insulating
jacket is over the conductors .
8 .
The power cord support hook can be moved up or down
by loosening and tightening the Allen screws .
Pad
WARNING DO NOT OPERATE MACHINE WITHOUT THE PAD IN PLACE .
Install or replace the pad if it has become matted down to a thickness of 3/8" or less .
•
1 .
Unplug machine, secure handle tube in vertical position, and lay down the machine, turning it over its wheels until
the underneath side of the machine is vertical and fully exposed .
NOTE: Place a clean towel on the floor to keep the switch box from scratching .
2 .
Remove the existing pad, then center new pad over grip face . Press pad against grip face until the hooks in the driver
have set in the pad .
3 .
Return the machine to the upright position .
4 .
Your floor machine is now ready to be used .
NOTE: Always leave a pad on the machine to protect the grip face from damage .
WWW.LAVEX.COM
Fig . 1
Fig . 2
Loosen
Tighten
User Manual
Handle Tube
Handle Clamp
Screw
Safety Nut
Wheel
Yoke
Adjustment Knob
5