Toyota 01999-YY052 Guia De Inicio Rapido página 16

TRAILER ATTACHMENT GUIDE
Mounting the Bracket and Camera
• Use the MOUNTING BRACKET HOLE PATTERN on the last page to mark locations of
mounting holes to be drilled. Install the included rivet nut into the mounting holes using
the following procedure.
A. Using the MOUNTING BRACKET HOLE PATTERN,
mark the locations for the drill holes.
B. MOUNTING BRACKET HOLE PATTERN instructions.
1. Mark holes using template with a hole
punch or marker.
NOTE: Ensure the Mounting
Bracket Hole Pattern is level
to the trailer during installation.
Recommend using a level and
installing while on flat, level surface.
2. Drill pilot hole with ⅛ inch drill bit.
3. Drill finished hole using 5/16 inch drill bit.
4. Clean any burrs from the finished hole after drilling.
NOTICE: Edges of holes may be sharp.
Wireless Camera System Quick Start Guide 13