Publicidad
Fuel and oil
Fueling the engine
• Follow the safety guidelines for fuel handling (page 5).
• Wait for the engine to cool down completely before
fueling.
• Place the brush cutter on a flat surface.
• Clean around the fuel tank cap to prevent contamina-
tion.
• Loosen the fuel tank cap slowly.
• Carefully pour the fuel mixture into the tank, taking care
CAUTION
to avoid spills.
specifications (page 3).
• Before replacing the fuel tank cap, inspect and clean the
gaskets.
• Immediately replace the fuel tank cap and tighten it by
hand.
• Clean up any fuel spills.
Engine starting
Cold start
• Set the gas brushcutter on levelled ground using care
the blade is not making contact with any obstacle.
• Set the switch into the ON position (A).
• Press and release the Starter choke 10 times (B).
• Move the Starter choke lever upwards (C).
• Press simultaneously the trigger release and the throttle
trigger. Still holding the trigger, push in the throttle lock
button and release the trigger.
• Pull the jack-line (D) to start the motor. DO NOT pull
more than 4 times to prevent flooding the motor.
• If the motor does not start, move the Starter choke lever
downwards (E). Pull again the jack-line (F) until the motor
starts. DO NOT pull more than 6 times (although, in cold
weather the jack-line has to be pulled more time).
• If the motor is still not starting, repeat steps from (B)
and on.
• Once the motor starts, leave it running a couple of
seconds in that position.
• Press and release the throttle trigger to run the motor
idle (G).
• The gas brushcutter is ready to operate. Hold both handles
and lift it to start the job.
Follow the fuel
CAUTION
In a new engine, it is normal to have
smoke emissions during and after its first use.
A
C
E
B
x6
x4
D
x6
F
G
ENGLISH
9
Publicidad
