Publicidad
Idiomas disponibles
Idiomas disponibles
5....-05-WE 611
Headphone Socket
GB
Please use headphones with a 3.5 mm jack, which should be inserted in the
socket (16). The loudspeakers are then switched off.
HOLD OFF/ON (3):
TONE LOW/HI (10):
1. Push the holding switch (3) to the OFF position.
2. Please press the band selector switch FM / POWER ON (7). The FM con-
trol lamp (6) shows the machine is on standby.
3. Turn the volume control (9) to set the volume high enough so that you can
clearly hear a hiss or a station that has already been set.
4. Select the desired band with the band selector buttons (5/7) (see frequency
table under "Technical Data").
5. Extend the telescopic antenna (15) and turn it until reception improves.
6. With the frequency range switch (12) you can select the frequency range of the
SW band (SW = shortwave), which is divided up into 10 sections.
7. With the TUNING control (8) you can tune in to the desired station. The current
frequency is displayed on the station scale (14).
8. Once a station has been correctly set, the red TUNE control lamp (2) lights up.
9. After use, press the POWER OFF button (1) to switch the device off.
NOTE: The TUNE control lamp only lights up in the FM band or in the case of
strong interference transmitters as it is not possible for recognition to take place
between the transmission signal and the interference signal (this is usually noticea-
ble due to the strong hiss). If you are inside a building or on a train, place the devi-
ce near a window in order to improve reception.
•
Always remove the plug before cleaning the device.
•
Any marks on the surface can be wiped off with a slightly damp cloth without
any additives.
•
Do not use any additives or solvents! These may damage the inscriptions or
even the housing.
This device has been tested according to all relevant current CE guidelines,
such as electromagnetic compatibility and low voltage directives, and has been
constructed in accordance with the latest safety regulations.
Subject to technical changes without prior notice!
26
26.02.2004
8:48 Uhr
This blocks the functions of all buttons on the device as pro-
tection against unintentional release of a button.
Set the desired tone using this switch.
Operation
Cleaning and Maintenance
Seite 26
Publicidad
