Publicidad
Idiomas disponibles
Idiomas disponibles
8.5
Fitting the dust filter bag (FIG I)
Insert the rod (18) into the two holes on the edge of the upper dust bag opening. Thread the
clamp (20) through the guide sewn into the dust bag (19). Fit the dust bag over the dust bag
opening. Tighten the clamp ring.
9 OPERATION (FIG J)
▪
Place the dust extractor next to the woodworking machine in a way that it will not interfere
with your work.
▪
Connect the suction hose to the dust extraction port of the woodworking machine. Use 1
of the supplied adapters (FIG J) as needed.
▪
Connect the power supply cable into a mains outlet.
▪
Turn the motor ON and wait a few seconds, until the fan has reached full speed. If the
upper dust bag does not fill with air after a few seconds, pull it up.
▪
Only now start the woodworking machine and commence with your work.
▪
Let the dust extractor run for at least 10 seconds after the woodworking machine has been
turned of.
9.1
Electrostatic Charging
The entire extraction system of the machine is constructed of electrically nonconductive
components. If the suction hose is connected to electrically conductive parts (eg metal dust
chutes or suctions pipes), they need to be earthed to dissipate possible electrostatic
energy.On the machine no plastic parts may be replaced by metal parts. The suction hose in
particular must not be retrofitted with a metal spiral. In this context small metal parts like
screws and hose clamps are harmless. Use only genuine spare parts. These spare parts are
designed for the machine.
9.2
Overload Protection
To protect the electric motor against overloads it has a motor protection built
in. If the motor is overheated or overloaded the machine will shut off.
In this case the motor can be restarted after a few minutes of cooling down.
If the machine is shut OFF repeatedly by a tripped motor protection (2–3 times) within a short
time, the machine needs to be checked by a qualified electrician, before attempting to turn it
ON again.
10 CLEANING AND MAINTENANCE
Attention! Before performing any work on the equipment, pull the power
plug.
10.1
Cleaning
▪
Keep the ventilation slots of the machine clean to prevent overheating of the engine.
▪
Regularly clean the machine housing with a soft cloth, preferably after each use.
▪
Keep the ventilation slots free from dust and dirt.
▪
If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
Copyright © 2023 VARO
POWX2090
7
p a g e
|
EN
www.varo.com
Publicidad
