Palmer PWT08MK2 Manual De Instrucciones página 3

USER MANUAL
PWT08MK2
INTENDED USE
This product is a power supply for effect devices.
Any other use and use of the product outside the specified technical data and operating conditions is considered
improper use!
Liability for damage and third-party damage to persons and property due to inappropriate use is excluded!
The product is not suitable for:
Persons (including children) with limited physical, sensory or mental abilities or lack of experience and knowledge.

Children (children must be instructed not to play with the device).

SAFETY INSTRUCTIONS
1. Please read these instructions carefully.
2. Keep all information and instructions in a safe place.
3. Follow the instructions.
4. Use the device in the prescribed manner only.
5. Do not open the device and do not perform any modifications.
CHOKING HAZARD! KEEP OUT OF THE REACH OF CHILDREN! THE PRODUCT CONTAINS SMALL PARTS THAT
CAN BE SWALLOWED AS WELL AS PACKAGING MATERIAL THAT CAN BE SWALLOWED! PLASTIC BAGS MUST BE
KEPT OUT OF THE REACH OF CHILDREN!
CAUTION! Risk of damage due to reverse polarity!
Make sure that the polarity of the DC input of the corresponding effect device matches the polarity of
the DC outputs of the power supply (barrel positive, centre negative). Connecting an effects unit with a
DC input with reversed polarity to this power supply can result in damage to the device.
CAUTION! Risk of damage due to overvoltage!
Make sure that the output voltage of the power supply corresponds to the input voltage requi-
red for the effect device. Effect devices can be damaged by overvoltage.
CAUTION! Risk of damage due to DC voltage at the AC voltage input!
Do not connect an effects unit that requires an AC voltage supply to this power supply unit. In some
cases, this could damage the effects unit and/or the power supply.
The total current requirement of all connected effect devices must not exceed 2000 mA. If the limit of
2000 mA is exceeded, a protective circuit prevents damage to the power supply unit. In this case, the
DC voltage outputs are switched off. When the error has been rectified, the device returns to normal
operation after approx. 2 seconds.
EN
Universal 8-way power supply unit for
effect devices
3