Publicidad
Idiomas disponibles
Idiomas disponibles
INDEX
7.7 COMPLETION AND CHECK
- Operate the down run control, manually setting the lower limit switch. Downward movement should stop.
- Operate the up run control until the carriages are fully raised and make sure the upper limit switch engages to stop these.
- Fill the post tanks with ESSO GEAR OIL GX 85W – 140 up to indicated level (refer to ch. 10).
- Fit in the pulley sensor plate on both columns Fig. A. Check that there is a gap of 0.5 mm between the sensor and the pulley (Fig. B).
- Fit in the covers as shown in Fig. C:
• Fit in the cover (1) by fixing it to the supports (2);
• Fit in the cover (3) by fixing it to the cover (1) and to the supports (4)
• Fit in the cover (5) by fixing it to the covers (1) and (3).
The identification plate must be always clearly visible after installation.
D
E
C
B
1
Fig. A
A
C
F
G
2
4
5
A
TBEI
M6X20
M6X12
Q.T. 16
A
C
A
C
SPM55-XEL
Fig. B
B
C
D
E
TBEI
ROND.
DADO ES.
ROND.
Ø6,4
MEDIO
Ø6,4
NERA
ZN
Q.T. 4
Q.T. 4
Q.T. 4
Q.T. 20
F
G
TE
ROND.
M6X14
ELAST.
Ø6,4
Q.T. 4
Q.T. 4
3
Fig. C
0473-M010-0
EN_19
Publicidad
