Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
Before performing a leak test, be sure that no sparks can occur and you are in a spacious
outdoor area. Connect the propane gas tank to the regulator and turn the valve on the unit to
the 'OFF' position. Brush a soap and water mixture on all connections. Turn the gas supply
on; if bubbles occur on any connection there may be a leak. If you smell gas or a leak is
discovered turn the gas valve off, disconnect propane gas tank and do not use the appliance
until the leak is repaired.
Do not use the heating unit without inspecting the gas hose. If there are signs of wear or
abrasion you must replace the hose (if applicable). Pumice stones/lava rocks/LavaGlass
could pop up and strike somebody's face during the process of lighting this unit for the first
20 minutes after igniting. Flame height should be a yellow/blue color between 2-10 inches in
height.
Wait 50 minutes after extinguishing flame prior to placing a lid or protective cover
(if applicable) on heating item.
To Light
1. Be sure to remove the lid before lighting the fire pit.
2. To light the fire pit, push and turn the control knob (G) on the side of the body (B)
counterclockwise to ignite the piezo ignition. It may take several attempts to light the
ignition.
3. To adjust the flame, turn the control knob (G) either clockwise or counterclockwise
depending on whether you want to lower or raise the flame.
To Extinguish
1. Push and turn the control knob (G) clockwise to turn off fire pit.
2. After fire pit is completely cool, lock lid in place by turning clockwise.
WARNING: Fire product and propane gas
cylinder minimum distance must be over
60 inches (as per right side photo).
WARNING: If the burner does not ignite
with the burner control valve open, gas
will continue to flow out of the burner and
could accidentally ignite causing injury or
property damage.
10
®
10
in
25
cm
2
in
5
cm
60 "
Publicidad
