Transport And Storage; 1. Conditions For The Transport And Storage; Instructions For Ordering Spare Parts; Troubleshooting - Technoflex VAF-38LT Manual De Instrucciones

4

TRANSPORT AND STORAGE

4.-1 Conditions for transport and storage
The packaging of the HIGH FREQUENCY transmissions allows its easy transport without taking any
special precaution.
Its storage the HIGH FREQUENCY transmissions if it is for a long period of time, its storage will be in a
safe dry place.
Before storage and after use the transmissions must be perfectly cleaned outside, taking all the
concrete removing, this operation can be carried out be hydro jet avoiding the electric parts.

INSTRUCTIONS FOR ORDERING SPARE PARTS

5
The spare parts are on sale at the official dealers and from the distributors of the make in your
neighbourhood.
When you require spare parts do not forget to indicate:
-The type of the vibrator, and diameter of the needle.
-Units required, code and description of the parts ordered and whenever possible provide the serial
number of the machine.
-Indicate also the delivery means preferred, the delivery will be made in the means desired.
6

TROUBLESHOOTING

SYMPTOM
The motor needle
doesn't work
The needle makes more
noise than normally
The needle stops when
it is vibrating the
concrete
Doesn't start with below
temperatures
The needle revolves
with a slow speed and
warm it
PROBABLE CAUSE
-Electrical connections are let or broken
-Faulty switch
-Fail of the line
-Faulty bearing
-The thermal protection switch off
-The grease is solidified
-Voltage line is low
-Blocked bearings
-The motor rotor frictioned
COUNTERMEASURE
-Checking and replace if it
necessary
-Replace
-Checking plugs of converter
-Replace them with original spare
-Checking electrical parts and
bearings
-Starting the vibrating needles
to work without load enough
time until it works normally.
-Checking output voltage of the
converter must be (48 V.)
-Replace bearings with original
spare
-Sending to our factory or Official
Agent