Descargar Imprimir esta página

camry Premium CR 6313 Manual De Uso página 4

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 18
damaged in any way or does not operate normally. Do not repair the device yourself, as this
may result in electric shock. Take the damaged device to the appropriate service center for
inspection or repair. All repairs may only be performed by authorized service points.
Improperly performed repairs may pose a serious threat to the user.
16. Place the device on a cool, stable, even surface, away from hot kitchen appliances such
as an electric stove, gas burner, etc.
17. The power cord must not hang over the edge of the table or touch hot surfaces.
18. To provide additional protection, it is advisable to install a residual current device (RCD)
in the electrical circuit with a rated residual current not exceeding 30 mA. In this regard,
please contact a specialist electrician.
19. If it is necessary to use an extension cord, use a model with only a grounding pin and
rated for a current of at least 10 A. Extension cords that do not meet this requirement may
overheat. The cable should be placed in such a way as to avoid accidental pulling or tripping
over it.
20. Do not allow the motor part of the device to get wet.
21. The device should be placed on an even, temperature-resistant surface, away from
flammable materials (curtains, drapes, wallpaper, etc.). To ensure proper air circulation,
leave at least 10 cm of free space on each side of the device and at least 30 cm above it. Do
not cover the ventilation holes of the device, as this may cause overheating and damage to
the product.
22. Do not touch the hot surfaces of the device (door, upper or lower wall, and side walls).
Use protective gloves when removing or touching any hot components.
23. The power cord must not be placed above the device and should not touch or lie near hot
surfaces. Do not set devices under the electrical socket.
24. Do not put portions occupying its entire volume into the device, as this may cause fire and
destruction of the product.
25. After baking or before cleaning the appliance, disconnect the power plug from the socket
and allow it to cool down. Please wait long enough as the heated device cools down very
slowly.
26. Clean the device after each use.
27. Do not use aggressive detergents in the form of emulsions, milks, pastes, etc. to clean
the housing, as they may, among other things, remove informative graphic symbols such as
scales, markings, warning signs, etc.
28. Do not use metal scrapers for cleaning. Broken pieces of wire may come into contact with
electrical parts, posing a risk of electric shock.
29. The equipment is not intended to be operated using external timers or a separate remote
control system.
30. Due to the high temperature, be especially careful when removing baked food, removing
hot fat, or other hot liquids.
31. Do not place the appliance under kitchen cabinets due to heat and steam.
32. Do not wash metal parts in dishwashers, because aggressive agents used in these
4

Publicidad

loading