GSE GT 1210 Manual Del Usuario página 17

GT1210
RECOMMENDATIONS FOR USE:
Before using the beard trimmer the hair must be clean and dry. We recommend cutting small quantities of hair at a time, adjusting the cutting length
gradually until finding the one you want. The blades risk getting stuck if too fast movements are made or if a lot of hair is cut at the same time. It can
be used without attachment comb to trim beard, neck hair and sideburns.
CHARGING PROCESS:
Before charging the beard trimmer for the first time we recommend fully discharging the battery and then fully charging it.
1. Make sure that the appliance is switched off.
2. Plug the adapter into the power outlet and then connect it to the device. The charging LED will turn on and remain on throughout the charging
process. When charging is complete, the LED will turn off. Attention: to prolong battery life, the first charge should be much longer even if the
LED is off.
The first charge takes 12 hours. The time of the following charges is always 90 minutes. When fully charged, the battery will last about 60 minutes.
3. Disconnect the adapter from the outlet once the device is fully charged.
4. The beard trimmer may be used connected directly to the power outlet if the battery charge is depleted.
The duration of the battery varies based on usage frequency and times. To increase the lifespan of the batteries, this procedure should be carried
out at least twice every 12 months, discharging the battery completely and recharging it for the maximum time. If the appliance is not used often,
remember in any case to carry out a charging cycle every so often during the year to keep it working efficiently. On the contrary, when the charging
is finished, do not keep the appliance connected to the mains to prevent the battery from overcharging and damaging the appliance.
WARNING: Do not attempt to replace the internal battery of the beard trimmer. This can lead to the risk of fire or electric shock. Tampering
invalidates the warranty on the product.
CAUTION:
Lubricate the blade before the first use. Read the instructions contained in the section "HOW AND WHEN TO LUBRICATE THE BLADE"
USE INSTRUCTIONS:
•Insert the desired attachment. This operation should always be done with the beard trimmer turned off.
•Turn on the beard trimmer by pressing the ( ) button.
•Turn off the beard trimmer by pressing the ( ) button.
17