Publicidad
Idiomas disponibles
Idiomas disponibles
11.3 INSTALLATION AND USE (Assisted Rescue)
Step 1:
Install the FS810-3 Reinforced Cross Arm Strap and rescue device as previously described in Section11.0.
Step 2:
Connect the short end of the rope lifeline to the small D-ring of the FS810-3 Reinforced Cross Arm Strap.
Step 3:
The rescuer will then connect the rescue device to the front D-ring of their Full Body Harness.
Step 4:
The rescuer controls their descent rate by maintaining tension on the free end of the rope lifeline using one or both belays on the device
(Figure 17, Dwg 2).
Step 5:
To stop the descent and prevent further downward movement place the free end of the rope through the belay and into the rope lock. It's important to
avoid connecting the free end of the rope directly to the rope lock without routing the rope through belay first.
Step 6:
The rescuer will then connect the worker to the decent device rope lifeline using their preferred connection method.
Step 7:
With the fallen worker securely connected to the rescue device rope lifeline, the rescuer will raise both themselves and the fallen worker slightly in order
to disconnect the fallen worker from their fall arrest subsystem.
Step 8:
Once the fallen worker is disconnected from their fall arrest subsystem, the rescuer and worker can begin their descent.
Step 9:
When the rescuer and fallen worker reach the next lower safe level, they will disconnect from the system and continue with their pre-planned rescue
procedures.
FIGURE 17 - ASSISTED RESCUE / SINGLE RESCUER
V3.0 2023 Copyright Safewaze
11
Publicidad
