Russell Hobbs Adventure 23912-70 Manual Del Usuario página 5

USING YOUR KETTLE
1. Put the stand on a stable, level surface.
2. Plug the stand into the wall socket.
3. Put the kettle on the stand.
Move the switch to I.
4.
5. The kettle will start to heat.
6. When the water boils the kettle will switch off.
To switch off manually, move the switch to O, or simply lift the kettle off the stand.
7.
GENERAL
Note: When you lift your kettle, you may see moisture on the stand. This is normal and is caused by the
steam used to switch your kettle off automatically.
BOIL DRY PROTECTION
If your kettle boils dry, a safety cut-out device will automatically switch it off. If this happens, unplug your
kettle and allow it to cool down until the cut-out resets itself. Allowing your kettle to boil dry will shorten
the life of the element.
CARE AND MAINTENANCE
1. Unplug the stand, and let the kettle cool before cleaning.
2. Wipe all surfaces with a clean damp cloth.
3. Remove the lid.
4. Slide the filter up and out of the guides.
5. Rinse the filter under a running tap while brushing with a soft brush.
6. Slide the filter down, into the guides.
7. Refit the lid.
Descale regularly, (at least monthly).
Descale the appliance with a proprietary descaler. Follow the instructions on the package of descaler.
Products returned under guarantee with faults due to scale will be subject to a repair charge.
RECYCLING
W
To avoid environmental and health problems due to hazardous substances, appliances
and rechargeable and non-rechargeable batteries marked with one of these symbols
must not be disposed of with unsorted municipal waste. Always dispose of electrical
and electronic products and, where applicable, rechargeable and non-rechargeable
batteries, at an appropriate official recycling/collection point.
4