GE CHP9536 Manual Del Propietário página 11

Custom Settings
1. Press and hold All Off pad for 3 seconds, then
immediately press and hold the Timer Select pad for
3 seconds to enter custom settings. Those two pads
must be pressed within 30 seconds. Any other pad
will cancel mode.
2. "C - -" appears on display. To navigate through the
Custom Settings, use the A (up) or V (down) pads. If
A (up) is selected the display cycle starts at "C01". If
V (down) is selected, the display cycle starts at "C62".
3. To activate a new Custom Setting the user will touch
and hold the Timer Select pad for 3 sec. Only ONE
of the Custom Setting Choices can be activated for
each Custom Setting. The red "On" LED will turn on
and a sound will go off once a new custom setting is
activated.
4. The cooktop will exit Custom Settings if it is inactive
for 3 minutes.
5. To exit Custom Settings and save any changes, touch
and hold the All Off pad for 3 seconds.
Custom Settings Chart
Custom Settings Custom Setting Choices
CO (Factory Settings)
C02 - Custom settings activated (Not visible unless any other custom setting is selected. And
automatically on when any other custom setting is selected. Not selectable by user.)
Cl (Control Lock)
C12 - Auto Lock (ie; Engages after cooktop has been in standby mode for 10 minutes.) The unit should be
completely off to go into Auto Lock.
C2 (LED light level)
C22 - Medium illumination
C23 - Lowest illumination
C3 (Button Loudness)
C32 - Button sound level reduced by 50%, Alarm sounds at 100%
C33 - Button sounds deactivated, Alarm sounds activated at 100%
C4 (Timer Alarm Loudness)
C42 - Low
05 (Timer Alarm Duration)
C52 - Alarm sounds for 60 seconds.
C53 - Alarm sounds for 30 seconds.
C54 - Alarm sounds for 15 seconds.
06 (Timer Mode)
C62 - Multi-Timer (Tied to each element.)
* Options in grey are default settings
C
Z
I
m
0
0
0
• •
Cl
C
©
3
u')
r--b