Publicidad
Step 18
1
D12
Groove
å
Insert the DRAWER SIDES (D12 and D13 with label) at
an angle into the slot at each end of the UPPER LEFT
DRAWER FRONT (L).
3
M67
M67
1
Surface with
HIDDEN CAM
å
Push one HIDDEN CAM (1F) into the DRAWER
BRACE (M67). Then, insert the metal end of a CAM
DOWEL (2F) into the HIDDEN CAM.
å
Fasten the DRAWER BRACE (M67) to the UPPER LEFT
DRAWER FRONT (L). Tighten one HIDDEN CAM.
www.sauder.com/service
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
Label
D13
L
Arrow
Metal end
1F
2F
Hidden part using
recycled material.
Color may vary.
L
2
U n fi
s u r
D12
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Slide the DRAWER BOTTOM (D733) into the
grooves in the DRAWER SIDES (D12 and D13)
and UPPER LEFT DRAWER FRONT (L).
4
D12
M67
å
Fasten the DRAWER BACK (D128) to the DRAWER
SIDES (D12 and D13) and DRAWER BRACE (M67). Use
five BLACK 1-9/16" FLAT HEAD SCREWS (30S).
å
Repeat this step for the remaining upper drawer using
the UPPER RIGHT DRAWER FRONT (M).
430079
1
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
n i s h
e d
f a c
e
D733
L
D13
Start each screw a few turns before
completely tightening any of them.
30S
BLACK 1-9/16" FLAT HEAD SCREW
(10 used in this step)
D128
Be sure the
D13
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
9
Page 23
Publicidad
