Jackery Explorer 1000 Manual Del Usuario página 5

7
AC Wall Charging Indicator
10
Low Battery Indicator
13
High Temperature Warning
16
Remaining Discharge Time
19
Battery Power Indicator
UPS:
Once you have connected the mains and the AC input port of the product via the AC charging cable,
you can use the AC output port of the product to power your unit (at this point the AC power comes
from the mains, not the battery of the product). In the event of a sudden loss of mains power, the
product can automatically switch to battery mode within 20ms. This product does not support 0ms
switching. Do not connect to equipment with high uninterruptible power requirements such as data
servers and workstations. Please test several times to confirm compatibility before use and it is
recommended to connect to only one device. Do not use more than one unit at a time to avoid
triggering the overload protection. Failure to follow these instructions may result in equipment failure or
loss of data for which we cannot be held responsibl
Battery Power Indicator
When the product is being charged, the orange circle around the battery percentage will
light up in sequence. When charging other devices, the orange circle will stay on.
Low Battery Indicator
When the battery is less than 20%, the Low Battery Indicator will stay on. When less than 5%,
the Low Battery Indicator will flash. When it is being charged, this Indicator will be o .
Energy Saving Mode
To avoid forgetting to turn o the output which results in battery consumption, the product
turns the Energy Saving Mode on by default. This occurs when no device is connected or the
connected device is less than or equal to a certain value. (Refer to the table below for more
details), the device will automatically turn o all outputs after 12 hours.
Output
AC Output
USB Output
Car Output
To turn o the Energy Saving Mode
Long press the AC Button and Main Power Button until the Energy Saving Mode icon
disappears. In Non-Energy Saving Mode, please remember to turn o the products to avoid
battery consumption.
To turn on the Energy Saving Mode
Long press the AC Button and Main Power Button until the Energy Saving Mode icon lights up
on the screen.
8
Car Charging Indicator
11
Remaining Battery Percentage
14 Low Temperature Warning
17
Output Power
Output Power Defaults
≤25W
All outputs turned o automatically after 12 hours
≤2W
≤2W
9
Solar Charging Indicator
12
Fault Code
15
Energy Saving Mode
18
AC Power Indicator
US
03