Publicidad
Idiomas disponibles
Idiomas disponibles
Immediately
prepare
your lawn mower for
storage
at the end of the season
or if the
unit will not be used for 30 days or more.
LAWN MOWER
When lawn mower
is to be stored for a
period of time, clean it thoroughly,
remove
all dirt, grease,
leaves,
etc. Store in a
clean, dry area.
1. Clean
entire
lawn mower
(See
"CLEANING"
in the Maintenance
section
of this manual).
2.
Lubricate
as shown
in the Mainte-
nance
section
of this manual.
3. Be sure that all nuts, bolts, screws,
and
pins are securely
fastened.
Inspect
moving
parts for damage,
breakage
and wear.
Replace
if necessary.
4. Touch
up all rusted or chipped
paint
surfaces;
sand lightly before
painting.
HANDLE
You can fold your lawn mower
handle for
storage.
1. Loosen
the two (2) handle
knobs on
sides of the upper handle
and allow
handle to fold down to the rear.
2. Squeeze
the bottom
ends of lower
handle
toward
each other until pins in
handle
clear the brackets
and pivot
entire
handle
assembly
forward
and
allow it to rest on mower.
• When
setting
up your handle from the
storage
position,
the lower handle will
require
manually
locking
into the
mowing
position.
IMPORTANT:
When folding
the handle
for storage
or transportation,
be sure to
fold the handle
as shown or you may
damage
the control
cables.
Operator I:
control bar
Upper
Lower
handle
FOLD
BACKWARD
Mowing
position
SQt
Handle
bracket
pin
J
ENGINE
FUEL SYSTEM
IMPORTANT:
It is important to prevent
gum deposits
from forming
in essential
fuel system parts such as carburetor, fuel
filter, fuel hose, or tank during storage.
Also, alcohol
blended fuels (called
gasohol or using ethanol or methanol)
can attract moisture which leads to
separation
and formation
of acids during
storage. Acidic gas can damage the fuel
system of an engine while in storage.
1. Drain the fuel tank.
2. Start the engine and let it run until the
fuel lines and carburetor
are empty.
• Never
use engine
or carburetor
cleaner
products
in the fuel tank or permanent
damage
may occur.
• Use fresh fuel next season.
NOTE:
Fuel stabilizer
is an acceptable
alternative
in minimizing
the formation
of
fuel gum deposits
during storage.
Add
stabilizer
to gasoline
in fuel tank or
storage
container.
Always
follow the mix
ratio found on stabilizer
container.
Run
engine
at least 10 minutes
after adding
stabilizer
to allow the stabilizer
to reach
the carburetor.
Do not drain the gas tank
and carburetor
if using fuel stabilizer.
ENGINEOIL
Drain oil (with engine warm)
and replace
with clean engine oil. (See "ENGINE"
in
the Maintenance
section
of this manual).
16
Publicidad
