Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 1
Separate the nozzle from the detergent container by turning the
detergent tank counterclockwise and separating the two components.
STEP 2
Fill the detergent container with an approved detergent. Pour the
detergent slowly into the tank using a funnel. Re-attach the two
components by re-inserting the nozzle into the detergent tank and turn
clockwise.
STEP 3
To apply the detergent cleaner to your work area, attach the detergent
nozzle to the gun. Turn the pressure washer switch to the ON position.
Press the trigger to start the unit. The pressure washer will mix the
detergent with water. Do not allow the detergent to dry on the object
being cleaned.
Instruction manual
CLEANING AND STORAGE
TURNING OFF THE PRESSURE WASHER
When you have finished using the pressure washer, follow these steps
to turn the unit off:
▶Turn the pressure washer to the OFF position.
▶Turn off the water supply.
▶Before disconnecting the high pressure hose connection, point the
▶Disconnect the high pressure hose from the pressure washer and
▶Disconnect the garden hose from the pressure washer.
▶Remove the quick coupling connector from the garden hose and
▶Remove excess water from the pump by tilting the unit to both sides
▶Remove the water inlet filter and rinse it with water to remove any
▶Empty the detergent tank and rinse it under running water.
▶Clean any water residue from all parts and accessories.
▶Set the safety lock on the gun.
▶Store the pressure washer, parts and accessories in an area with a
WINTERIZING AND LONG-TERM STORAGE
Follow the shutdown procedure above, adding the following steps:
▶After disconnecting the water supply and before
▶Always store the pressure washer, parts and accessories in an area
23
WARNING: Never use products containing bleach, chlorine
or other corrosive materials, including solvent-based
liquids (e.g., gasoline, oils, etc.), trisodium phosphate
products, ammonia or acid-based cleaners. These
chemicals can cause damage to the unit and the surface
being cleaned. Always read the product label first.
gun in a safe direction and discharge the water under high pressure.
the gun.
attach it to the nozzle part of the connector installed on the pressure
washer for storage.
to drain the remaining water from the inlet and outlet fittings.
dirt or debris. Replace the filter once it is clean.
temperature above 0 °C (32 °F).
disconnecting the high pressure hose, switch on the pressure
washer for 2 to 3 seconds, until the remaining water in the
pump comes out.
WARNING: Turn the unit off immediately. Continued use of
the pressure washer without turning on the water supply
will cause severe damage to the unit!
with a temperature above 0 °C (32 °F).
ref. 08472
ES
PT
EN
FR
Publicidad
