Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY INFORMATION
6. Do not "jam" the wheel or apply excessive pressure. Do not attempt to make an
excessive depth of cut. Overstressing the wheel increases the loading and susceptibility to
twisting or binding of the wheel in the cut and the possibility of kickback or wheel breakage.
7. When wheel is binding or when interrupting a cut for any reason, switch off the power
tool and hold the power tool motionless until the wheel comes to a complete stop.
Never attempt to remove the wheel from the cut while the wheel is in motion
otherwise kickback may occur. Investigate and take corrective action to eliminate the
cause of wheel binding.
8. Do not restart the cutting operation in the workpiece. Let the wheel reach full speed
and carefully re-enter the cut. The wheel may bind, walk up or kickback if the power tool is
restarted in the workpiece.
9. Support panels or any oversized workpiece to minimize the risk of wheel pinching
and kickback. Large workpieces tend to sag under their own weight. Supports must be
placed under the workpiece near the line of cut and near the edge of the workpiece on both
sides of the wheel.
10. Use extra caution when making a "pocket cut" into existing walls or other blind
areas. The protruding wheel may cut gas or water pipes, electrical wiring or objects that can
cause kickback.
Additional Safety Rules
1. Know your power tool. Read operator's manual carefully. Learn its applications and
limitations, as well as the specific potential hazards related to this tool. Following this
rule will reduce the risk of electric shock, fire, or serious injury.
2. Always wear eye protection with side shields marked to comply with ANSI Z87.1.
Failure to do so could result in objects being thrown into your eyes, resulting in possilbe
serious injury.
3. Protect your lungs. Wear a face or dust mask if the operation is dusty. Following this
rule will reduce the risk of serious personal injury.
4. Protect your hearing. Wear hearing protection during extended periods of operation.
Following this rule will reduce the risk of serious personal injury.
5. Inspect tool cords periodically and, if damaged, have repaired at your nearest
authorized service center. Constantly stay aware of cord location. Following this rule
will reduce the risk of electric shock or fire.
6. To reduce the risk of electrocution, keep all connections dry and off the ground. Keep
the tool dry when applying water to the cutting wheel. Do not stand in water when operating
the tool. Do not touch the plug with wet hands. Keep bystanders away from water and
electricity.
10
Publicidad
