Descargar Imprimir esta página

Oster OGGME2701 Manual De Instrucciones página 26

Publicidad

Idiomas disponibles

Idiomas disponibles

COUNTERTOP INSTALLATION
Prior to Installation
Remove all packing material and accessories. Examine the oven for any damage such as dents or broken door.
Do not install if oven is damaged.
Cabinet: Remove any protective film found on the microwave oven cabinet surface. Do not remove the light
brown Mica cover that is attached to the oven cavity to protect the magnetron.
Installation
Select a level surface that provide enough open space for the intake and/or outlet vents.
12 inch(30cm)
OPEN
3.0 inch(7.5cm)
3.0 inch(7.5cm)
1) The minimum installation height is 85cm.
2) The rear surface of appliance shall be placed against a wall. Leave a minimum clearance
of 30cm above the oven, a minimum clearance of 20cm is required between the oven and any adjacent walls.
3) Do not remove the legs from the bottom of the oven.
4) Blocking the intake and/ or outlet openings can damage the oven.
5) Place the oven as far away from radios and TV as possible. Operation of microwave oven may cause
interference to your radio or TV reception.
6) Plug your oven into a standard household outlet. Be sure the voltage and the frequency is the same as the
voltage and the frequency on the rating label.
WARNING: Do not install oven over a range cook top or other heat-producing appliance. If installed near or
over a heat source, the oven could be damaged and the warranty would be voided.
The accessible surface may be hot during operation.
English-9

Publicidad

loading