Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING!
•
Only operate generator on a level surface.
•
Always connect the nut and ground terminal on the frame to an appropriate ground source.
How to Start Engine (See fig 9-16)
Place generator on a level surface. All electrical loads MUST be disconnected from generator.
•
GAS
•
Turn fuel valve to the "ON" position. (See fig 10)
•
Turn the fuel selector to "GAS" position
•
Slide the choke lever to the "Choke" position. (See fig 12) SKIP THIS IF THE ENGINE IS WARM OR HOT.
•
For electric start, Push and hold the engine START/ON/OFF switch in the "START" position. Do not hold the START/
ON/OFF switch in the "Start" position for more than 15 seconds. Allow 1 minute between starting attempts. (See fig13)
•
For manual start, turn the engine START/ON/OFF switch to the "ON" position. Pull the recoil handle (starter
cord) slowly until resistance is felt, then pull rapidly. (See fig 14)
•
Let engine run for several seconds and then gradually, as engine warms up, slide the choke lever towards the "RUN"
position until the choke is fully slid to the "RUN" position. (See fig 15)
•
LPG
•
Connect the gas pipe to the intake nozzle of regulator ; Open the valve of LPG bottle
•
Turn the fuel selector to "LPG" position
•
Slide the choke lever to the "Choke" position. (See fig 12) SKIP THIS IF THE ENGINE IS WARM OR HOT.
•
For electric start, Push and hold the engine START/ON/OFF switch in the "START" position. Do not hold the START/
ON/OFF switch in the "Start" position for more than 15 seconds. Allow 1 minute between starting attempts. (See fig13)
•
For manual start, turn the engine START/ON/OFF switch to the "ON" position. Pull the recoil handle (starter
cord) slowly until resistance is felt, then pull rapidly. (See fig 14)
•
Let engine run for several seconds and then gradually, as engine warms up, slide the choke lever towards the "RUN"
position until the choke is fully slid to the "RUN" position. (See fig 15)
Fig 9
START
Fig 13 Electric Start
OPERATION
Generator must be properly grounded to prevent electrocution.
(See fig 11)
(See fig 11)
Fig 1 0
START
Fig 14 Recoil Start
Fig 1 1
RUN
CHOKE
Fig 15
13
(See fig 9)
RUN
CHOKE
Fig 12
SKIP THIS IF THE
ENGINE IS WARM OR HOT.
Publicidad
