Publicidad
Idiomas disponibles
Idiomas disponibles
Reversing The Door
Warning! When changing the way the door opens, the appliance must not be connected to
the mains.
Remove the plug from the mains before working on the door.
1. Remove the two screws (6) and remove the worktop (7) by raising the rear and pushing
it forwards.
2. Remove the two screws (1) and remove the upper hinge (5) from the right side of the
cabinet.
3. Lift the door off the lower hinge pin and place in a safe location to avoid damaging it.
4. Remove the foot (3) and the two screws (8) and then remove the lower hinge (2) with
hinge pin (9).
5. Unscrew the left front foot (4) and transfer to the right side.
6. Unscrew the hinge pin (9) from the lower hinge (2) and screw it into the other side
(reversed).
7. Screw the lower hinge (2) into place on the bottom left side with the two screws (8).
8. Re-fit the foot(3) on the bottom left side.
9. Slot the door onto the lower hinge pin and align with the cavity opening in its closed
position.
10. Remove the blanking plug from the hole on the top left of the door and transfer to the
right side.
11. Screw the upper hinge (5) into place with screws (1) on the top left side of the cabinet.
12. Make sure the hinge pin on the top hinge locates in the hole in the top left of the door.
13. Make sure you have tightened all the screws securely.
14. Re-fit the worktop(7) in reverse order of step 1.
FIGURE 1
FIGURE 1 - REPRESENTATIVE POSITION OF COMPONENTS PRIOR TO
FIGURE 2 - REPRESENTATIVE POSITION OF COMPONENTS AFTER
DOOR REVERSAL.
DOOR REVERSAL.
FIGURE 2
10
Publicidad
