TO KNOW YOUR THERMO POT
Main Parts Diagram
Water pump lid
Lid lock knob
Control panel
Water outlet
Cup switch
Water level
indicator
Refill mark
Receptacle
Full line
Upper lid hinge
6
www.NutriChefKitchen.com
Control Panel
Steam escape holes
Pump lock
Upper lid
Handle
USING THE THERMO POT FOR THE FIRST TIME
1. Wash and rinse the water tank with water.
2. Fill the water up to the full mark.
Power Inlet
3. Boil once and discard the water by pumping it out.
Base
REMOVE AND ATTACH THE LID
Power cordPlug
Detach Lid
Place the handle towards the rear side of the thermo pot.
Base
Then open the lid by pulling up the lid opening lever (caution: be careful of
the steam from the steam vent). Position the lid at a 45-degree angle and
pull out the lid from the hinge holder by pressing the hinge lock.
Note: Never remove the lid while the water is boiling.
Detachable upper lid
Attach Lid
Place the handle towards the rear side of the thermo pot.
Gasket
Press the hinge lock, at the same time insert the shaft of the hinge of the
lid into the hinge holder. Ensure that the lid is attached properly and close
the lid until it clicks.
Water tank
OPERATING THE APPLIANCE
To open the lid and boil water:
Pull the lid opening lever up to open the lid and fill water into the water tank.
Always fill water above the minimum water level mark and below the
maximum water level mark. Refer to the water level mark in the water tank.
7
www.NutriChefKitchen.com