NUTRICHEF PKWK43 Manual Del Usuario página 5

To close the lid:
Close the lid by pressing down until it clicks. Do not close the lid by force.
Connect the Power Cord to the Hot Water Dispenser:
Insert the receptacle into the power inlet.
Then, insert the plug into the wall outlet.
WARNING: Do not power on the appliance if the water tank is empty.
Connect the plug to the power inlet horizontally.
1. "Boiling" indicator light will be on during the boiling
process.
2. It will switch to "Keep Warm" automatically after the
water is boiled.
•
Do not open the lid or dispense water while the
water is boiling.
•
Do not contact any parts of your body to the
steam vent.
•
Do not place cloth or any other items to cover the steam vent.
Pouring hot water:
1. Note: The hot water may not dispense smoothly right after boiling.
2. Press on the "DISPENSE" button to dispense hot water.
•
CAUTION: Always keep hands or any parts of your body away from
the water outlet for a second or two right after you press the dispense
button.
•
Do not press the dispense button when the inner water reservoir is
empty.
•
You cannot dispense hot water by pressing the dispense button, or
cup switch if the thermo pot is unplugged.
Refill water:
When water reaches the "refill water" line, add water for automatic re-boil.
•
Do not add water above the maximum water level mark.
•
Boil water below the refill mark may cause malfunction.
8
www.NutriChefKitchen.com
To re-boil water under keep warm mode:
•
It takes about 3 minutes to re-boil water (with a full water tank).
•
Before re-boiling the water, make sure the water level is above the refill
mark.
•
When adding water into the water tank, be careful of the hot steam from
the steam vent and water tank.
•
Once the re-boil button is pressed, the boiling process will begin and you
cannot reset any button until it turns to keep warm mode.
•
Do not press the re-boil button continuously (after the re-boiling process)
as it may cause malfunction.
CLEANING AND MAINTENANCE
1. Always allow the appliance to cool down before cleaning.
2. Remember to unplug the plug from the wall socket and power inlet.
3. Open the lid and pour out the remaining water in the water tank.
4. Wipe the lid and body with a damp cloth.
•
Never immerse any part of the thermo pot in water.
•
Never splash water on the control panel.
•
Do not use abrasive materials to clean the appliance.
5. Discoloration of the water tank and white floating objects in the water
tank:
•
Red rust-like spots, milky or black discoloration, and white floating
objects are caused by minerals in the water and are not caused by
discoloration or deterioration of the water tank itself. Although this is
not a hygiene problem, you are advisable to clean the water tank
periodically.
•
Cut a lemon into four pieces and wrap the lemon in the cloth then put
in the water tank.
•
Pour water up to the full level mark in the water tank.
•
Boil the water and then retain the heat for about one hour.
•
Pour out the water and use a nylon brush to clean the water tank.
•
To remove the smell of the lemon, you can boil the water again and
dispose of the water.
6. Stainless steel water reservoir
•
Wash the water tank with a sponge and then rinse with clean water.
IMPORTANT: Do not use the following to clean the container.
•
Dish soap (causes an unpleasant odor)
Scrubbing powder or scrubbing brushes (it will damage the container
and lid.)
•
Benzene (causes damage to the plastic of the lid)
9
www.NutriChefKitchen.com