Publicidad
Idiomas disponibles
Idiomas disponibles
Intended use
• This appliance is intended to be used for commercial applica-
tions, for example in kitchens of restaurants, canteens, hos-
pital and in commercial enterprises such as bakeries, butch-
eries, etc., but not for continuous mass production of food.
• The appliance is designed for heating and defrosting of food
products using appropriate dishes. Any other use may lead to
damage to the appliance or personal injury.
• Operating the appliance for any other purpose shall be
deemed a misuse of the device. The user shall be solely liable
for improper use of the device.
Grounding installation
This appliance is classified as protection class I and must be
connected to a protective ground. Grounding reduces the risk
of electric shock by providing an escape wire for the electric
current.
This appliance is fitted with a power cord with grounding plug
or electrical connections with grounding wire. The connections
must be properly installed and grounded.
Control panel
(Fig.1 on page 3)
1. Defrost
2. For USB operation
3. Power
4. Time Entry
5. Double quantity or triple quantity
6. Number Keyboard
7. Pause
8. Start
Spare parts or accessories
(Fig.2 on page 3)
9. USB card
Preparation before use
• Remove all protective packaging and wrapping.
• Check that the device is in good condition and with all ac-
cessories. In case of incomplete or damaged delivery, please
contact the supplier immediately. In this case, do not use the
device.
• Clean the accessories and the appliance before use (See ==>
Cleaning & Maintenance).
• Make sure the appliance is completely dry.
• Place the appliance on a horizontal, stable and heat resistant
surface that is safe against water splashes.
• Keep the packaging if you intend to store your appliance in
the future.
• Keep the user manual for future reference.
NOTE! Due to manufacturing residues, the appliance may emit
a light odor during the first few uses. This is normal and does
not indicate any defect or hazard. Make sure the appliance is
well ventilated.
Operating instructions
Power Up
When plug into the socket, "---" will be shown on the display.
It will disappear in 1 minute of inactivity. Then, this microwave
will enter into the Idle Mode.
Idle Mode
During idle mode, the screen display "E" and there will be no
oven activity. Opening and then closing the oven door will ac-
tivate the ready mode. The oven will enter idle mode after a
minute of no use, The time it takes to activate idle mode can
be changed with the 'user options' (Option 4, Timeout Window).
Ready Mode
Opening and closing the door while the oven is in Idle Mode will
put the oven into Ready Mode. In this mode, the oven is ready
to either begin a manual or preset cooking cycle. During Ready
Mode, "READY" displays. From the Ready Mode, the oven can go
to almost all of the other modes.
Door Open Mode
Door open mode is activated by opening the door. During this
mode, the screen display "DOOR" and "OPEN". And the fan and
oven lamp work. When the oven was working when the door
was opened the program will be paused.
Manual Entry Mode
Make sure the microwave is under "READY" mode. Select the
time with the 'Time Entry' button, the display will show "00:00",
select the requested time with the number keyboard. After that,
select the power level. Press 'Power' button first and then se-
lect the power level with the number keyboard as shown in be-
low table (Defrost /10%/20%/30%/40%/50%/60%/70%/80%/90
%/100%), The display will show the selected power. If you press
again the same power level button, the power will be back to
set 100% power. Also, if no power level button is set, the power
will be default to 100%. When everything is set press the 'Start'
button, now the microwave will start operating. At the end of
the cycle the display will show 'DONE' or beeps will be heard
until the microwave is opened or the 'Pause' button is pressed.
Pause Mode
This mode allows users to pause the cycle to inspect or stir the
food. While the microwave is operating open the door or press
the 'Pause' button to pause the cycle. The display will show the
remaining time. To resume the cycle, close the door and press
the 'Start' button. When nothing is done the microwave will go
into idle mode.
Run program mode
This microwave comes with preset programs. When the micro-
wave is in 'Ready mode' press one of the number keys and the
microwave will run the program. Below you'll find the preset
programs. When operating the microwave shows the remaining
time in the display, when it's a multi-stage program the total
remaining time will be displayed.
GB
9
Publicidad
