LEGRAND LN310082 Manual De Instalación página 26

4.2.2 Cold start
1. Make sure the internal battery is fully charged.
2. Connect the loads in the back-up sockets.
3. Press the ON/OFF button to start-up the UPS and power the loads. The blue and red leds are lit
for 3 seconds along with a 3 seconds long acoustic signal. After that, the blue led blinks once
and there are two beeps.
INDICATION
The output frequency is set to 50 Hz.
4.3 Shutdown
1. Press and hold the ON/OFF button until the blue led turns off.
2. The UPS stops powering the back-up outlets.
3. Unplug the UPS from the mains power supply socket to stop powering also the overvoltage
protected outlets.
4.4 LED and Alarm Indicators
NORMAL MODE/
BATTERY MODE LED
Steady
LED blinking every 3
seconds
LED blinking every 3
seconds
LED blinking every 2
seconds
Steady
OFF
Steady
OFF
ALARM
ALARM
LED
OFF OFF
OFF OFF
1 beep every 10
OFF
seconds
1 beep every 2
OFF
seconds
OFF Intermittent
Continuously
Steady
sounding
1 beep every 10
Steady
seconds
Continuously
Steady
sounding
KEOR MULTIPLUG
600 VA - 800 VA
UPS STATUS
The UPS is operating in normal mode
UPS operating in battery mode with
battery status 40%-100%
UPS operating in battery mode with
battery status 20%-40%
UPS operating in battery mode with
battery status <20%
Overload in normal mode
UPS shutdown due to prolonged
overload
Battery fault
UPS fault (other than overload)
25