cRadia CRA 6015 Manual De Usuario página 33

Single Phase 240V Mode Wiring
To have single 240V output, connect the Jumper between
terminal H2, H3(default status). Then
independent phase between H1& H5.
Output socket and terminal block are available for output
connection from UPS.：
Model
CRA 6012
CRA 6025
CRA 6040 / 6050
Please find rated output capacity of product, avoid overload and used wire with sufficient current rating, with refer
to below table.
Model
CRA 6012
CRA 6025
CRA 6040 / 6050
Procedure for output wiring:
1. Plug the AC input cord of the equipment needs UPS protection to the output socket of the UPS.
2. To connect more equipment than available output socket number, please use extension cord, connect to the
output socket or output terminal block, mind the total consumption current must not exceed rated current
capacity of the product.
3. The output terminal is protected by a cover, uncover the terminal, use appropriate connecting terminal, prepare
well the wire.
4. Fix the prepared wired to the terminal block, find the silkscreen marking for polarity of the wiring.
Use only battery bank of correct voltage, check the product rating label for correct information.
Choose Wire with sufficient current rated, prepared well the terminal.
CHECK THE POLARITY of battery bank, fix wires of correct polarity to the battery bank with
proper color and clear label for distinguish the polarity.
33
you can have Dual
Rating Capacity
1.5kVA
2.5kVA
4/6kVA
Nominal Output Voltage
220V/230V/240V
220V/230V/240V
220V/230V/240V
Quantity of output socket
6
8
NA
Rated output Current
10A
15A
30A
EN
Output terminal block
NA
Available
Available
Wire for terminal
> 14AWG/2mm2
> 14AWG/2mm2
> 10AWG/5mm2