GE 22 Manual Del Propietario E Instalación página 25

Installation Instructions
I_ PUT THE REFRIGERATOR IN PLACE
Move the refrigerator to its final location.
r_ LEVEL THE REFRIGERATOR
The refrigerator can be leveled by adjusting the
rollers located near the bottom hinges.
....... :_
__ - _- .....................
Rollers _
Raise
Rollers have three purposes:
• Rollers adjust so the door closes easily when
opened about halfway. (Raise the front about
5/8" [16 mm] from the floor.)
,, Rollers adjust so the refrigerator is firmly
positioned on the floor and does not wobble.
• Rollers allow you to move the refrigerator
away from the wall for cleaning.
To adjust the rollers on 23' (33" wide), 25', 26',
27' and 29' models:
• Turn the roller
adjusting screws
clockwise to raise
the refrigerator,
cou nterclockwise
to lower it. Use a
3/8" hex socket
or wrench, or an
adjustable wrench.
Roller adjusting screw
r_ LEVEL THE REFRIGERATOR (cont.)
B1
To adjust the
rollers on 23725'
CustomStyle" models:
Turn the front roller
adjusting screws
clockwise to raise
the refrigerator,
counterclockwise to
Roller adjusting screws
lower it. Use a 3/8" hex
wrench with extension, or an adjustable wrench.
These models also have rear adJustable
rollers so you can align the refrigerator with
your kitchen cabinets. Use a ]/8" hex wrench
with extension to turn the screws for the rear
rollers-clockwise to raise the refrigerator,
counterclockwise to lower it.
LEVEL THE DOORS
Adjust the refrigerator door to make the doors
even at the top.
To align:
Using a 7/16" wrench, turn the door adjusting
screw to the right to raise the door, to the left
to lower it.
NOTE:
A nylon plug, imbedded in the threads of the
pin, prevents the pin from turning unless a
wrench is used.
After one or two turns of the wrench, open
and close the refrigerator door and check the
alignment at the top of the doors.
Doors should be even at top
I
25