Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Tips on use:
NOTA:
1. The machine may overheat after a long time of use, this is a normal phenomenon. Let the machine cool down for a while and
you can use it again when the temperature drops.
2. After completing the pruning work, at the end of the season, or when you replace the blade, and need to remove the blade, add
lubricating oil for the maintenance of the blade and the cutting system.
While pruning, start pruning about 8mm from the bud; the maximum cutting diameter is 25mm.
Prune in the part furthest from the bud to avoid loss of sap in the plant.
Do not prune the branches too far away from the tree, as it will reduce the health of the plant. Leave a small section
of the branch to avoid stress on the plant.
While working with the pruner, keep your hands away from the cutting blades and equip suitable gloves and
protective equipment.
When pruning a tree, prune each branch separately and do not cut multiple branches at once.
Battery charging:
The battery in a new machine is not fully charged. Before charging, insert the battery into the charger and insert the charger plug
into the outlet. The "+" of the battery should be inserted into the "+" of the charger, as shown in the image to the right. The charger
indicator light will turn green once fully charged. Always use the battery after full charges.
Special attention:
1. Before charging, turn off the switch; During charging, it is normal to have a slightly warm charger and batteries.
2. If the batteries are not used for a long time, they should be recharged every 3 months to increase the service life.
3. New batteries or batteries not used for a long time will reach the maximum capacity after 5 times of charge-discharge cycles.
4. Do not charge the batteries repeatedly after several minutes of operation, this may reduce the working time and the effective-
ness of the batteries.
5. Do not use damaged batteries or disassemble the charger or batteries.
6. Batteries can explode in fire. Never burn the batteries.
7. Do not charge the batteries in an outdoor or humid environment.
8. With the gradual decrease of the electric quantity of the battery, it is normal to reduce the capacity of the cutting diameter.
9. During the charging process, do not use the pruner.
5
Publicidad
