Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Sharpening the blade:
To perform any maintenance on the pruner, you must completely cut off its power supply.
1. Turn the pruner off with the blade open and remove the battery.
2. Both sides of the movable blade are sharpened using sharpening stone forming the section angle with the blade.
3. After sharpening the blade, clean it, connect and turn on scissors, test that it moves properly, and close the blade for future
work.
Blade replacement:
To perform any maintenance on the pruner, you must completely cut off its power supply.
1. Use a phillips screwdriver to loosen the two screws on the top cover and remove it as shown in Figure 1.
2. Use the provided special tools to loosen the screws and anti-loosening washer, as shown in Figure 2.
3. Use a special tool to loosen the lock nut and remove the stop washer, as shown in Figure 3.
4. Remove the old movable blade and replace it with a new one, as shown in Figure 4.
5. If necessary, lubricate the blade as shown in Figure 5.
6. If necessary, clean the gears (warning: do not use chemical reagents) and grease them, as shown in Figure 6.
7. Install the blade and gear on the pruner, as shown in Figure 7.
8. Put on the stop washer and lock the lock nut, as shown in Figure 8.
9. Tighten the lock screw and anti-loosening washer, close the upper cover and tighten the screw as shown in Figure 9.
6
NOTE: Shim and moving blade can be re-
placed independently. When doing so, don't
be afraid of too small a blade opening. After
electricity, the normal aperture size will auto-
matically recover.
Publicidad
