Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
3
Installing the supply connections
□
Before Installing the supply connections, unscrew
the screws (K), and remove the plaster guard (L),
the sleeve (1), bonnet nut (2), cartridge (3) and
o-ring (4) from the valve body (D).
NOTE: The hot water supply lines go into the "H" inlet, and the cold water supply lines go into the "C" inlet. Do not use PEX or CPVC
between the valve body (D) and tub spout (J).
3a
Installing the supply
connections
□
Wrap thread sealant tape (not included) around the
pipe threads in a clockwise direction, as shown.
□
Connect the hot and cold water supply lines (1,
not included), the shower outlet pipe (2, not
included), and tub outlet pipe (3, not included)
by threading them into the valve body (D) in a
clockwise direction.
□
Tighten the pipes to the valve body (D) with a
pipe wrench (not included).
□
Connect the pipe elbows (4, not included) to the
end of the shower outlet and tub outlet pipes.
D
1
NOTE: If you do not wish to install the tub outlet, insert
the plug (I) into the bottom of the valve body (D).
D
1
4
2
3
1
4
2
I
1
L
K
3b
Installing the supply
connections (for soldering)
□
Before soldering, remove the stop valves (6) with
adjustable wrench.
□
Solder the hot and cold water supply lines (7,
not included), the shower outlet pipe (8, not
included), and tub outlet pipe (9, not included)
into the valve body (D) with the torch.
□
Solder the pipe elbows (10, not included) to the
end of the shower outlet and tub outlet pipes
with the torch.
□
Reinstall the stop valves (1) with adjustable
wrench.
2
1
NOTE: If you do not wish to install the tub outlet, insert
the plug (I) into the bottom of the valve body (D).
2
1
8
4
3
2
1
5
3
D
4
2
5
3
D
I
2
D
Publicidad
